- Tandberg LCD TV INSTRUCTION MANUAL E5714, E5740-xxx

Operating the Equipment Locally
Page 4-68 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
Table 4.68: Baud Rate Options
Selected Option Description Selected Option Description
1200 1200 Baud rate. 9600 9600 Baud rate.
2400 2400 Baud rate. 19200 19200 Baud rate.
4800 4800 Baud rate. 38400 38400 Baud rate.
RS232 PID Option
The RS232 PID option is selected from the Data A - RS232 Menu by
pressing the RS232 PID softkey. The option is used for entering or
updating data PIDs. Enter a PID using the softkeys, then press the Enter
softkey to accept it.
To be DVB compliant, PIDs below 32 are reserved. Therefore PIDs 32 to
8191 are available for use. In the event of a clash, one of the PIDs will be
changed by the Encoder’s internal checking algorithm.
Delay Option
The Delay option is selected from the Data A - RS232 Menu by pressing
the Delay softkey. The option cannot be changed.
SNMP oid index Option
The SNMP oid
8
index option is selected from the Data A - RS232 Menu by
pressing the SNMP oid index softkey.
All option modules have the same SNMP oid with the exception of one byte
which identifies which slot the module is in. An MEM expects the data
module to be in slot two or three in the previous version of the Encoder.
Therefore, slots one and two in this Encoder have been allocated to
correspond directly to slots two and three in the previous Encoder.
In this Encoder the data module can be allocated to slot one, making it
inaccessible to an MEM. This variable allows the on-board data module to
be apparently moved around - to a slot in which it may be referenced by
the MEM.
Table 4.69: SNMP oid index Options
Selected Option Description
Min: 1
Max: 7
Oid index
4.10.3 Data B - RS422 Menu
Encoding Option
To access the Encoding option, press the Encoding softkey in the
Data B - RS422 Menu. This enables the RS-422 synchronous data channel
to be switched On or Off.
8
oid = object identifier.