Operation Manual

18
CONNECTION TO TV SET AND DIGITAL OUTPUTS
It is possible to connect the MCS-650 to the TV set in several different ways, depending on what kind of video
input connections your TV set features.
Scart (Sound and picture)
Only one cable is needed to connect to the TV set. This connection enables you to get CVBS and RGB picture
to you TV set. To get RGB picture through the Scart cable, you must set the Video output to RGB in the setup
menu.
Please notice that the sound output in the Scart connecter is volume regulated.
Component video (YPbPr/YCbCr) (Only picture, no sound)
To use the component video output, you must connect all three cables (Y,Cb,Cr/Y,Pb,Pr) in the correct order.
To get component video picture to your TV set, you must set the Video output to YUV in the setup menu. It is
active as standard. When using the component video connection you have the ability of using progressive
scan. To activate progressive scan press the P.SCAN button on the remote. If your picture distorts or
disappears when running progressive scan, press the P.SCAN button once again, to change back to
Interlaced scan.
Note: Progressive scan is only available on component video.
S-Video (Only picture, no sound)
Connect this output to your TV set through a S-Video cable. No adjustments in the setup menu is needed.