User Manual

Using a single LIFE BUD
1. Make sure both LIFE BUDS are inside the case, and your phone or other
device’s Bluetooth is turned o .
2. Open the lid and take out the Right LIFE BUD. The LED will  ash blue
and red. (If using the Left LIFE BUD instead ,  rst press MFB until the
LED  ashes blue and red.)
3. Turn on the Bluetooth mode on your phone or device, and search for the LIFE
BUD on the screen. Click and connect it. When connected successfully, the
LED will  ash blue slowly.
Troubleshooting tips
1. If your phone cannot  nd the LIFE BUDS, please check that the LIFE BUDs are
on matching(blue and red LED  ashing). If the LIFE BUDs are not matched
for a long time, please turn on the LIFE BUDS to match again, or press
around three seconds until LED  ashes blue and red. Sometimes it is better
to reset the LIFE BUDS and the Bluetooth function of the phone.
2. If it is not possible to talk or listen to music while connected successfully:
You might need to choose Bluetooth “Mobile Audio” or “Media Audio” when
using an Android system, or please choose Bluetooth on call interface.
3. If your phone or device is paired/connected with the LIFE BUDS but there is
no sound: Try removing the LIFE BUDS as a Bluetooth device and then pair
with your phone or device a second time.
Speci cations
Bluetooth
Bluetooth version V 5.0
Wireless range 10 meters (with no obstacles)
Support model HSP / HFP / A2DP / AVRCP
Frequency Range 2402 to 2480 MHz
Channel No. 79
Max Output Power 10 dBm
LIFE BUDS Performance
Output 10 mW
Frequency Response 20 Hz to 20 kHz
Battery (LIFE BUDS)
Capacity 3.7 V/50 mAh
Charging time (approximately) 1 hour
Usage time (approximately)
Music playback 4 hours
Phone calls 4 hours
Standby 120 hours
Charging Case
Battery capacity 3.7 V/450 mAh
Charging time (approximately) 2 hours
LIFE BUD recharges 3 full charges
Power input Micro USB, 5 V / 1 A
Physical
Operating temperature -10C to 50C
Dimensions (charging case) 68.5 x 32 x 33.5 mm
(2.7 x 1.26 x 1.32")
Weight (including charging case) 43 g (0.09 lbs)
Other important information
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit di erent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Caution!
The Music Tribe is not responsible for any radio or TV interference caused by
unauthorized modi cations to this equipment.
Such modi cations could void the user authority to operate the equipment
FCC RF Radiation Exposure Statement:
(1) This Transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
(2) This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment.
LIFE BUD LEDs
Red LED  ashing: The battery charge is low.
Red LED on: Charging (when in the charging case).
Red LED on momentarily: Power turned o .
Blue LED  ashing very slowly: The LIFE BUDS are working.
Blue and red LED  ashing: LIFE BUDS pairing.
Using both LIFE BUDS
There are two methods to set up the LIFE BUDS, and each may be used:
Method one
1. Make sure both LIFE BUDS are inside the case, and your phone or other
device’s Bluetooth is turned o .
2. Open the lid and the LIFE BUDS will auto-power on and enter pairing mode.
3. The left LIFE BUD will  ash blue, and the right will  ash blue and red and
wait for the connection with your phone or device.
4. Turn on the Bluetooth mode on your phone or device, and search for the
LIFE BUD on the screen. Click and connect it. When connected successfully,
the LEDs on both LIFE BUDS will  ash blue slowly.
Method two
1. Make sure both LIFE BUDS are inside the case, and your phone or other
device’s Bluetooth is turned o .
2. Open the lid and take out the Right LIFE BUD. The LED will  ash blue and red
and wait for the connection with your phone or device.
3. Turn on the Bluetooth mode on your phone or device, and search for the
LIFE BUD on the screen. Click and connect it. When connected successfully,
the LED will  ash blue slowly. The  rst LIFE BUD is connected.
4. Take out the Left LIFE BUD. The LED will  ash blue once, and it will be
connected automatically.
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE INFORMATION
LIFE BUDS
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Procyon Street
Las Vesgas, NV89118
USA
Phone Number: [phone]
LIFE BUDS
This equipment has been tested and found to comply with the limits for a ClassB
digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
1. Register online. Pleaseregister your new Music Tribe equipment right
after you purchase it by visiting tannoy.com. Registeringyour purchase using our
simple online form helps us to process your repair claims more quickly and e ciently.
Also, read the terms and conditions of our warranty, ifapplicable.
2. Malfunction. Should your Music Tribe Authorized Reseller not be located in your
vicinity, you may contact the Music Tribe Authorized Ful ller for your country listed under
“Support” at tannoy.com. Shouldyour country not be listed, pleasecheck if your problem
can be dealt with by our “OnlineSupport” which may also be found under “Support”
at tannoy.com. Alternatively, please submit an online warranty claim at tannoy.com
BEFORE returning theproduct.