Quick Start Guide

ManualsBrandsTannoy ManualsIn-Wall Speakers2 Way 4" Dual Concentric In-Wall Loudspeaker (White)

14 iW Series Quick Start Guide 15

iW62 Backcan

Optional pre-install backcan for iW 62DS-WH and iW 62S-WH models. The backcan comes with its own installation instructions.

Accessories

Installation Templates (supplied)

Wiring and Setting Up

Terminal Panel Connections and Driver Earthing

1. WARNING: To avoid potential damage to your loudspeaker, ensure that the amplier is switched OFF prior to connecting or disconnecting any cables.

2. Before switching the amplier ON, double check that all connections are secure and that the polarity is correct.

Connection

The screw terminals are designed to take loudspeaker cable of AWG24 to AWG12 in size.

1. Strip o approximately 8 mm (¼") of the outer protective layer and twist the inner cores together. Insert the core and use a small at screwdriver to secure,

ensuring that correct polarity is maintained see Figs 1 to 3.

2. Run cabling from one pair of speaker terminals, back to the amplier, ensuring the correct polarity. The other set of terminals are a link that can be run

to another speaker.

Connection of Earth or Ground Lead - iW 6DS and iW 62DS

1. The iW 6DS and iW 62DS models have an extra terminal designed to optimise performance further by taking advantage of the driver earthing facility. Use a

shielded or screened loudspeaker cable; connecting the screening termination to the earth or ground (green) terminal on the loudspeaker and to the ground or

earth connection on the amplier.

2. Alternatively if you are not using a screened loudspeaker cable but wish to utilise the earthing facility, run a single cable between the earth or ground (green) terminal

on the loudspeaker to the earth (ground) connection on the amplier.

3. Switch the amplier on with the volume control set at its lowest setting. Select a favourite source and slowly turn up the volume to a low level. Check that bass and

treble information is being reproduced from the speaker. If not, switch o the amplier and recheck the connections.

Fig. 1 iW 4DC Fig. 2 iW 6DS Fig. 3 iW 62DS Fig. 4 iW 62S

iW 6DS-WH INSTALLATION TEMPLATE

INSTRUCTIONS

iW 62DS-WH INSTALLATION TEMPLATE

INSTRUCTIONS