SUB SUB owner’s manual
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
FUSE PROTECTION IMPORTANT NOTICE FOR THE UNITED KINGDOM (Connecting the plug and cord) The wires in the mains lead are coloured in accordance with the following code: BLUE - NEUTRAL BROWN - LIVE As the colours of the wires in the mains cable may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
WARRANTY No maintenance of the TS Subwoofer is necessary. This equipment has been produced and tested with care and precision. It is built to give first class service and carries a 2 year warranty on the electronics and 5 years on the drive unit.
ALWAYS MAKE AND CHECK ALL CONNECTIONS BEFORE PLUGGING THE SUBWOOFER INTO THE MAINS. Connection may be made either at LINE level, using the phono connectors on the back of the unit, or using the nearby speaker HI LEVEL terminals, which require bare wire or 4mm speaker plugs. FOR LINE LEVEL CONNECTION For use with an AV receiver or DVD receiver, connect a screened phono cable from the receiver SUB output to either RIGHT or LEFT low level phono input on the rear of the subwoofer.
SETUP Controls This menu is accessed by pressing the ENTER (centre) button for more than three seconds, and gives access to the following options, selected by the UP and DOWN buttons: LOWPASS- This is used to adjust the subwoofer’s upper frequency limit to achieve a correct balance with the main speakers. The LEFT and RIGHT buttons give a range of 50Hz to 150Hz.
Voltage Select Off On CAUTION: For continued protection against risk of fire,replace only with same type fuse and rating. ATTENTION: Utiliser un fusible de rechange de meme type et calibre. AC Line In 120V~60Hz 3.15A 220-240V~50Hz 1.6A 120V:T3.15A L 250V 220-240V:T1.
+ Right _ Hi Level In _ Left + 120V:T6.3A L 250V 220-240V:T3.15A L 250V 120V~60Hz 6.3A 220-240V~50Hz 3.15A ATTENTION: Utiliser un fusible de rechange de meme type et calibre. CAUTION: For continued protection against risk of fire,replace only with same type fuse and rating.
TECHNICAL SPECIFICATION TS801 TS1001 TS1201 Output Power 200W RMS 300W RMS 500W RMS Low Frequency Response (-6dB) (Typical In Room) 29Hz 24Hz 21Hz Inputs 2 x Phono Line Level, 2 x Speaker Level Input Filter 50-150Hz, 2nd Order Low Pass, with LFE Provision Auto Mute After Approximately 15 mins in Absence of Input Signal Driver Type 200mm (8”) Enclosure Type Enclosure Volume 250mm (10”) 300mm (12”) Closed Box, Forward Firing 16 litre (0.57 cu. ft.
notes
NOTES SUB
T: 00 44 (0) 1236 420199 T: 00 1 (519) 745 1158 T: 00 49 (180) 1111 881 T: 00 33 (0)1 7036 7473 E: enquiries@tannoy.com E: inquiries@tannoyna.com E: anfragen@tannoy.com E: ventes@tannoy.com Tannoy adopts a policy of continuous improvement and product specification is subject to change.
