Operation Manual

8. Software Installation
VSXNET Subwoofer Operation Manual rev 2.0.0
17
VNET Control Panel
ThecontrolpanelforVNETallowsVNETparameterstobeviewedandadjusted.Thepanelisorganisedintoamonitoring
area(atthetopleftofthepanel)wherethestatusofVNETmaybeviewed,andacontrolareawhereallthecontrolstoadjust
parametersarelocated.
NotethatParameteradjustmentsareautomaticallystoredintheDSPsectionofeachVNET-itisnotpossibletodo
temporarychangesthenstorethemseparately.

Parameterswhichcanbeadjustedbytheuserare:Crossover/Delay,EQ(Equalisation),Gain&Power.

TheCrossover/Delaytaballowsyoutoadjustthecrossoverfrequencies,crossovershapes&delays.

TheEQsections(8bands)allowyoutoadjustthefrequencyandlevel(boost/cut)foreachoftheequalisationlters,and
thebandwidth(Q)ofthebellequalisers.Thelattercontrolsallowtheresponsivenessofthelterstobeadjustedeitheras
bandwidth(Octaves)orQ.Theup/downbuttonswillchangethevalues.Valuesmaybetypedintoeitherthebandwidthor
Qpartofthebox.A‘FrequencyResponse’curveshowstheshapeofeachlterindividually(bycolour),andthecombined
effectofallequalisation(inwhite).
TherearealsoHigh&Lowshelvinglters.
Speaker Properties
Atthetopofthepanelthereareseveralpiecesofinformationabouttheconnecteddevice(whichareonlyactivatedwhen
goingOn-linetoadevice):-
Model Name
TheVNETmodelnumber
Loudspeaker name
Touniquelyidentifythespeaker(i.e.delay3)
Conguration Name
Anameofupto12charactersthatyoumayenterasanameforthecurrentsetofparameters.
Firmware Version
A4-digithexadecimalnumber,actingasasignatureforthecurrentsetofparameters.Thismaybe
  usedasaquickcheckthattheparametersloadedintoanX-Podareastheyshouldbe.
AlsoseeControls and Control Panels
Keyboard Shortcuts
Podwaresupportsthefollowing‘shortcuts’:-
  Tab   Movetonextcontrol
 Invalueboxes:
  CTL+C   Copy
  CTL+V   Paste
  CTL+X   Cut
  CTL+Z   Undo
 OnDrop-down,Spin,Push,Fadercontrols:
  PgUp   Increasevalue(coarsely)
  PgDown Reducevalue(coarsely)
  Up/Rightarrow  Increasevalue(nely)
  Down/leftarrow  Reducevalue(coarsely)
 Onpush-buttoncontrols:
  Space   Activate