VX SERIES Professional loudspeakers Quick Start Guide
Introduction Designed, engineered and built in the United Kingdom, the VX Series from Tannoy comprises a range of passive loudspeakers for demanding professional and commercial sound applications. Within the VX Series, system designers can choose from a variety of sizes, power levels and coverage patterns to suit particular requirements. This Quick Start Guide presents only the essential information required to properly unpack, connect and (when applicable) configure for bi-amp operations.
Unpacking Crossovers Each Tannoy VX Series loudspeaker is carefully tested and inspected prior to shipment. After unpacking, please check for any exterior physical damage, and save the carton and any relevant packaging materials in case the loudspeaker again requires packing and shipping. In the event that damage has been sustained in transit notify your dealer and the shipping carrier immediately. VX Series loudspeakers are supplied as standard for passive operation via the internal crossover network.
Bi-Amp Operation Rigging and Safety Procedures The VX 12HP, VX 12Q, VX 12.2Q, VX 15HP, VX 15Q only may be internally reconfigured for bi-amp operation to supply greater system headroom. Reconfiguration is as follows: Tannoy Professional loudspeakers should be installed only by fully qualified installers using dedicated Tannoy hardware, in accordance with all the required safety codes and standards that are applied at the place of installation. First, remove the rear termination panel.
