User manual

ManualsBrandsTANSUN ManualsHeating Devices & CablesQuartz IR radiator 1500 W 9 m² Silver Rio

©Tansun Limited 2010 Part No. 042088 Issue. 9

Reference Manual

Rio IP

UK, EUROPEAN & AUSTRALIA/NEW ZEALAND MODELS:

RIO 210IP UK, RIO 210IP EU & RIO 210IP ANZ

RIO 215IP UK, RIO 215IP EU & RIO 215IP ANZ

RIO 220IP UK, RIO 220IP EU & RIO 220IP ANZ

Spectrum House, Unit 1, Ridgacre Road, West Bromwich,

West Midlands, B71 1BW, England.

Tel: +44 (0)121 580 6200 - Fax: +44 (0)121 580 6222

Email: quartzinfo@tansun.com - Website: www.tansun.com

Summary of content (4 pages)

PAGE 1
Reference Manual Rio IP UK, EUROPEAN & AUSTRALIA/NEW ZEALAND MODELS: RIO 210IP UK, RIO 210IP EU & RIO 210IP ANZ RIO 215IP UK, RIO 215IP EU & RIO 215IP ANZ RIO 220IP UK, RIO 220IP EU & RIO 220IP ANZ ©Tansun Limited 2010 Part No. 042088 Issue. 9 Spectrum House, Unit 1, Ridgacre Road, West Bromwich, West Midlands, B71 1BW, England. Tel: +44 (0)121 580 6200 - Fax: +44 (0)121 580 6222 Email: quartzinfo@tansun.com - Website: www.tansun.
PAGE 2
Introduction Your Replacement Emitter The Rio IP heater produces radiant heat like the sun, warming people and objects rather than the air in between. It is mounted on an adjustable bracket that allows the heat to be directed exactly where it is required. Its attractive, lightweight design means that it is effective yet unobtrusive. The Rio IP is designed for indoor and outdoor use so is therefore weatherproof.
PAGE 3
17. From inside of the heater body, push one of the leads through the black rubber gasket and into the terminal box. The gasket has two small holes in it and one wire per hole should be inserted (the sleeving needs to be pulled back so only the white wire comes through) and push it firmly into either one of the terminals. Hold in place and tighten the screw fully (Fig. 17). RETAINING BRIDGE Fig. 17 Installation The Rio IP heater is fitted with 5.
PAGE 4
Replacing the Emitter If you are in any doubt about following the procedure below, please contact us for technical assistance. The mains power should be disconnected before any attempts are made to replace the emitter. The following should be carried out with compliance to I.E.E. regulations. Please read the notes on page 7 with regards to handling and buying a replacement emitter before proceeding. 1.