User manual

ManualsBrandsTANSUN ManualsHeating Devices & CablesQuartz IR radiator 3000 W 22 m² White Sorrento

F o l l o w i n g i n f o r m a t i o n i s o n l y f o r E U - m e m b e r s t a t e s :

The use of this symbol indicates that this product may not be treated as household waste. By ensuring this product is

disposed of correctly, you will help prevent potential negative consequences for the environment and human health,

which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about

recycling of this product, please contact your local council, your household waste disposal service or the shop where you

purchased the product.

©Tansun Limited 2012 Part No. 042221 Issue. 3b

Reference Manual

Sorrento IP

Double

UK & EUROPEAN MODELS:

SOR 210IPD, SOR 210IPD UK, SOR 210IPD EU,

SOR 215IPD, SOR 215IPD UK, SOR 215IPD EU,

SOR 220IPD, SOR 220IPD UK, SOR 220IPD EU.

Spectrum House, Unit 1 Ridgacre Road,

West Bromwich, West Midlands, B71 1BW, England.

Tel: +44 (0)121 580 6200 - Fax: +44 (0)121 580 6222

Email: quartzinfo@tansun.com - Website: www.tansun.com

Summary of content (4 pages)

PAGE 1
Following information is only for EU-member states: The use of this symbol indicates that this product may not be treated as household waste. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
PAGE 2
Introduction 8. Remove the screws from both sides of the middle reflector and lift it up to remove it (Fig. N). The Sorrento IP Double heater produces radiant heat like the sun, warming people and objects rather than the air in between. It is mounted on an adjustable bracket that allows the heat to be directed exactly where it is required. Its attractive, lightweight design means that it is effective yet unobtrusive.
PAGE 3
Replacing the Emitter If you are in any doubt about following the procedure below, please contact us for technical assistance. The mains power should be disconnected before any attempts are made to replace the emitter. The following should be carried out with compliance to the latest IEE regulations. If you are unfamiliar with installing such fixtures, contact a qualified electrician to carry out. Please read the notes on page 5 with regards to handling and buying a replacement emitter before proceeding.
PAGE 4
Joining Individual Heaters Together 9. Line-up the bars of the third heater with the brackets of the second heater – these should go on the outside faces like heater three. The Sorrento IP heater can be joined to other Sorrento IP heaters using the joining bars provided. A maximum of three individual heaters can be joined in one installation. 10. Push a bolt from the back of the long joining bars through the holes putting a serrated washer on each side of the heater bracket. 11.