User's Manual

Installing the RT-2200

Warning: Energized meters, meter sockets and distribution lines present

the risk of electrical shock. All work on this equipment should be

performed by qualified metering specialists or industrial electricians.

Personnel working with this equipment should follow all utility company

established operation and safety procedures.

BEFORE YOU BEGIN

1. Advise the customer to turn off any sensitive electronic equipment including computers,

stereos, televisions, etc.

2. Tell the customer that the power will be off for approximately 5 – 10 minutes.

Note: For safety reasons, we recommend you attach a clear meter

socket cover with a meter ring to the front of the RT-2200 unit prior to

installation.

INSTALL THE RT- 2200

3. Remove the existing meter from the meter socket.

4. Inspect the “jaws” of the meter socket to ensure that they are in good working condition

(ie: the jaws should not be spread too far apart).

[insert diagram of acceptable and unacceptable “jaws”)

5. Perform a voltage check, a line-to-line check, and a line-to-neutral check to ensure the

voltage is at proper levels.

6. Visually inspect the back of the RT-2200 unit to ensure the power pins on the front and

back are secure and everything is in place.

[insert diagram of back of RT-2200 with cotter pins in place]

7. Grasp the RT-2200 unit on the top left and bottom right corners and plug it into the

meter socket firmly.