User's Manual

Page
30
INSTALLATION AND MAINTENANCE
The thermostat must be in the Normal Operating Mode in order to access to the configuration
settings required for the installation and maintenance.
Mounting the Thermostat
Install the thermostat at 5 feet (1.5m) above the floor in an area with good air circulation at average
temperature. Avoid locations with drafts or dead spots behind doors, hot or cold air ducts, sunlight
or radiant heat from appliances, concealed pipes or chimneys and unconditioned areas such as
outside walls behind the thermostat.
The 2 wallplate anchors should be spaced 3.5 inches (90 mm) apart in a vertical direction. Pull
wires through the backplate and connect to the appropriate terminals as defined in the Wiring
Configuration.
Mounting the Remote Sensors
Outdoor sensors should be mounted in shaded locations, out of direct sunlight. The thermostat will
automatically detect an external sensor and display its readings.
Cleaning the Thermostat
The thermostat can be cleaned with a soft cloth lightly dampened with isopropyl alcohol (IPA).
Excessive IPA or use of other solvents may damage the LCD!