User Manual

16
15
LED display is on, no mist or
little mist is produced
Tank leakage
1
2
1
Mist height is low, damping
surrounding desk or oor.
Condensation forms around
humidier or on windows
and walls
Poor humidication
Tap water may contain too
much minerals
Replace with ltered or
distilled water or use with a
TaoTronics Demineralization
Cartridge
White Dust Appears / Black
coating in the base akes off
Unit needs to be cleanedStrange Odor
Water is going down to the
water reservoir
This is normal while it is
working
Strange water noise
Unit works for too long
Power off and place in a
well-ventilated place for 10
minutes
Humidier is getting too hot
Not enough water inside the
tank
Rell and reinstall the water
tank
Adjust to maximum mist
Check if current humidity is
higher than preset humidity,
reset humidity to a higher
level
Remove the tank, empty
the base & replace the
lled tank on the empty
base
Feel if air comes out from
the the nozzle, if yes, then
clean water scale on the
atomizer as instructed
Mist level is set too low
Preset humidity is set too low
The base might be overlled
Mineral buildup on atomizer
Check for possible cracks in
the tank, replace if
necessary
Tighten the tank cap
Check the tank cap for
rubber ring, rubber cap
and spring, contact us if
any is missing
Ensure the spring is
secured properly to the
tank allowing water to pass
through to the base
Tank may be damaged
Tank cap is not tightened
securely
Rubber ring was not
installed on tank cap
Spring stuck
1. Check if the room is too
humid, adjust to lower
mist, 40%-60% works best
2. Open door and windows,
or change to a larger
room
Humidier should be
placed on a hard at
surface, 2 feet above the
oor, 12 inches away from
the wall. Point Mist Outlet
away from wall or window
Raise the room temperature
to 25°C/77°F
Mist level is set too high for
the room size
Air inlet is blocked
Low indoor temperature
leads to liquefaction
1-1. Adjust to maximum mist
1-2. Close door or windows to
reduce air ventilation, or
change to a smaller room
Humidier should be
placed on a hard at
surface, 2 feet above the
oor, 12 inches away from
the wall
Raise the room temperature
to 25°C/77°F
Mist level is set too low for the
room size
Air inlet is blocked
Low indoor temperature
leads to liquefaction
Clean the humidier as
instructed
Leave the empty water tank
open in a cool place for 12
hours without the water
tank cap attached