TAOTRONICS SoundLiberty Pro S20 Questions or Concerns? support@taotronics.
CONTENTS YOUR EARBUDS (01-02) SETTING UP YOUR EARBUDS (03-04) USING YOUR EARBUDS (04-10) CLEANING AND MAINTENANCE (11) TROUBLESHOOTING (12-14) WARRANTY AND SERVICE (15) IMPORTANT SAFETY INSTRUCTIONS (16-17)
YOUR EARBUDS Acessories Eartips (L has been attached to the earbuds) Charging Slot Status Indicator Reset Button Charging Indicator S M L XL USB-C Charging Port QUICK START GUIDE Multifunction Touch Control Microphone 01 Charging Contacts SoundLiberty Pro S20 Noise Cancelling Microphone Charging Cable User Manual Quick Start Guide Thank You Card SoundLiberty Pro S20 02
SETTING UP YOUR EARBUDS Power ON/OFF Wearing 1 2 3 Charging ON OFF Uncover the lid to power on. Place earbuds back and close the case to power off. We highly recommend that you fully charge the earbuds before using them for the first time. 1. Place the earbuds into the charging case. 2. Close the case and connect to any USB charging port with the included cable. USING YOUR EARBUDS Bluetooth Caution • Place the two devices to be connected close to each other and turn off other Bluetooth devices.
Bluetooth Pairing - Binaural Mode Bluetooth Pairing - Mono Mode 1. Uncover the lid to turn on the earbuds, they will connect with each other automatically. 2. Turn on the Bluetooth function on your device and search for nearby devices. 3. Find “SoundLiberty Pro S20” in the search results, tap to connect. When Bluetooth connected, you can use either one of the earbuds as per your preference. Take out one earbud, and make sure the other one is placed in the case with the lid covered.
Controls and Functions Binaural Mode ANC on/off In-Ear Detection When either of earbuds is taken off under music, the music will be paused and earbuds will switch to ambient mode automatically.
Active Noise Cancelling 3 4 When in Binaural mode, ANC mode is turned on automatically after putting on both earbuds. Tap and hold the touch control on the left earbud to turn on/off ANC mode. Tap twice to activate ambient mode. ON 10s Press and hold the reset button for 10 seconds until the indicator on the case flash white three times. Ambient Mode Transparency Normal Mode Re-pair with your device as instructed.
CLEANING AND MAINTENANCE TROUBLESHOOTING Wipe only with a dry, soft cotton swab or equivalent. Cannot find the earbuds in the Bluetooth list • Deactivate the Bluetooth function of previously paired device or remove the earbuds from the Bluetooth list and connect again. Never insert anything into the nozzle. • Place the device to be connected close to the earbuds. Wipe only with a dry, soft cotton swab or equivalent.
No sound from one earbud • Make sure the earbuds are within range of each other. Earbuds do not turn on • Battery low. Place both earbuds back into the charging case to charge. • Make sure the in-ear detection sensor is not blocked. • Place both earbuds back to the charging case and then take them out. Failed to charge the Earbuds • Place both earbuds in the charging case properly until they magnetically snap into place. Poor sound quality • Clear any debris from the earbud nozzles.
WARRANTY AND SERVICE IMPORTANT SAFETY INSTRUCTIONS Please read the instructions thoroughly before using this product and retain it for future reference. This product is covered with TaoTroincs product and labor warranty for 12 months from the date of its original purchase. The warranty will not apply in cases of: • Accident, misuse, or repairs performed by unauthorized personnel. • Any unit that has been tampered with or used for commercial purpose. • Normal wear and tear of wearable parts.
• DO NOT clean the product with detergent containing alcohol, ammonia, benzene or abrasives. • Avoid dropping. • Place the earbuds back into the charging case when not in use and keep it away from children and pets to avoid choking hazard. The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Sunvalleytek International Inc. is under license. Other trademarks and trade names are those of their respective owners.
Rev_1.0_EN WEEE Compliance Correct Disposal of This Product (Waste Electrical & Electronic Equipment) (Applicable in countries with separate collection systems)This marking on the product, accessories or literature indicates that the product and its electronic accessories should not be disposed of with other household waste at the end of their working life.
