Installation Instructions

or go to the
Advance Search
Search
Tapcon Anchor
Installation Instructions
Product Information
:
Selection and Order Information
:
Suggested Specifications
Performance Data
:
Tapcon Condrive Tool Kit
:
Approvals and Listing
INSTALLATION STEPS
Read instructions before using (installation)!
WARNING!
If there are any questions concerning proper installation,
applications or appropriate use of this product, please call
our Technical Services Department at 1
-
800
-
899
-
7890.
Failure to follow these instructions can result in serious
personal injury.
1.
Select proper fastener
–
diameter/head style/length
a)
Use selection chart to choose proper length.
2.
Drill Hole
–
use selection chart to determine drill bit length and depth of
hole.
a)
Choose appropriate drill bit based upon diameter of Tapcon Anchor.
b)
Drill hole minimum ¼
”
deeper than Tapcon Anchor to be embedded.
Minimum anchor embedment: 1
”
Maximum anchor embedment: 1
-
3/4
”
3.
Drive Anchor
WARNING!
Failure to wear safety glasses with side shields can result
in serious personal injury. Always wear ANSI compliant
eye protection (ANSI Z87.1
-
2003)
WARNING!
Using the wrong size drill bit will affect performance values
and may cause faliure.
APPLICATIONS
Tapcon is especially well suited for window and door
frames because it performs well in block, is available in a
flat head style, and is fast to install.
Many horizontal or "wall" applications are attached with
Tapcon because it is removable and works well in block
and brick.
The picture shows the Condrive 1000 Installation Kit in
action. The kit makes for fast and easy change over from
drill bit to driver and controls the driving torque to prevent
thread stripping and head snapping in hard base
materials.
Tapcon Anchor Installation Instructions