User's Manual

NOTE: Make sure that your computer is turned on and has detected he

USB receiver before you set the ID code.

Now, you can launch your media player to confirm that the remote is

functioning properly.

Targus Stow-N-Go

Media Remote Control Card

Link

Indicator

connection

button

• The operation system identifies the receiver, prompts ”USB

Human Interface Device” and begins installation automatically.

Please follow the instruction on the screen to complete the

installation procedure.

Establishing a Communication Link

• If the remote is not working or you have recently replaced the

battery, you can try to reset the ID code between the receiver and

the remote. To do this, do the following:

This remote is a plug-n-play device. It should be operating once the

USB receiver is connected and recognized by the computer.

Press and release the connection button on the receiver. The LED

should glow red. Next, locate and keep pressing the connection button

on the back of the remote until the Link Indicator starts blinking. Now

the remote controller has re-linked with the USB receiver.

connection

button