User Manual
Targus Laser Presentation Remote Targus Laser Presentation Remote
10 11
folding line
Folded Size: 4.5” x 4.5”
Color: Grayscale for UG Diecut
(i) Targus will provide the purchaser with store return information or a return authorisation so
that the purchaser may return the product for warranty inspection, (ii) If after inspection Targus
finds the product is defective in materials or workmanship, Targus shall replace (or repair) the
defective product at the discretion of Targus and ship the product from Targus warehouse at its
expense within three business days (Monday to Friday excluding public holidays) of receiving
the returned goods. If the product is no longer available Targus reserves the right to replace
with the nearest corresponding product of no lesser quality, (iii) Targus will bear the cost of
return delivery to the purchaser regardless of the inspection test result. The purchaser must
bear the cost of the delivery to Targus. There is no charge for inspection. 6. Our goods come
with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and for compensation for any other reasonable
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if
the goods fail to be of acceptable quality and the failure does not amount to a major failure. 7.
Please note: (i) Features and specifications of all Targus products are subject to change without
notification, (ii) In some instances: Goods presented for repair may be replaced by refurbished
goods of the same type rather than being repaired. Refurbished parts may be used to repair
the goods, (iii) If goods accepted for repair retain user-generated data: During the process of
repair some or all of your stored data may be lost. Please ensure that you have saved this data
elsewhere prior to repair.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
FCC Statement
Tested to Comply
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
410-2789-001A_AMP22US_031313_CA cert usage.indd 10-11 14/3/13 9:58 AM