User's Guide

Targus Air Pointer
Targus Air Pointer
2
3
Introduction
Thank you for your purchase of the Targus Air Pointer. This combination
E-laser pointer features eight control buttons that emulate the command
keys in Power Point. It oers true plug-and-play capability with no need for
software drivers; the 2.4 GHz technology allows for eective presentations
at up to 66’/20 m.
Contents
• Air Pointer
• Wireless Receiver
• 1 x AAA battery
• User Guide
System Requirements
Hardware
• USB interface
Operating System
• Microsoft Windows® 10
• Microsoft Windows® 8.1
• Microsoft Windows® 8
• Microsoft Windows® 7
• Mac OS® X v10.14.5 -10.6
Installing the Battery
Ensure the device is o, using the switch located on the side of the presenter
to the “OFF” position.
Insert the supplied battery, making sure the positive (+) and negative (-) ends
of the battery match the polarity indicators inside the battery compartment.
Using your Remote
Plug the USB receiver into any USB port on your laptop for RF 2.4G mode
remote.
Switch to USB for RF 2.4G mode remote, switch to for Bluetooth
(version 4.2) mode remote.
Keys and Functions
LED Indicator
Dark
Screen
Next Slide/Forward
Previous Slide/
Backward
Volume Up
Volume Down
Start/Exit
Slideshow
Mouse Right Button
Erase (All)
E-Laser Pointer - in MS PowerPoint only
(hold the button to show red point)
OS
Switch
On/O
air mouse
Mouse
Left
Button
Pen
(Switch on air mouse first, then
hold Pen button to draw)
Establishing connection by Bluetooth
1. Enable the Bluetooth setting on your laptop/computer device.
2. Switch on presenter in Bluetooth mode. (Turn on the power by sliding
the OFF/USB/ switch on the right side). The blue LED will flash for
3 seconds while the device is reconnecting.
3. While the Blue LED is flashing, go to your laptop/computer Bluetooth
setting and select “Targus P38 Remote” Bluetooth device name.
4. The Bluetooth presenter is now connected to your laptop/computer.
5. If the pairing process takes longer than 3 minutes and the Blue LED
turns o, reset the power switch (“OFF” and back to “ ”) and follow
step 3 or manually press “Volumn Up” + “Volumn Down”, wait for the
Blue LED to flash and then follow step 3.
Reconnecting the laptop/computer device
If a Bluetooth device has been recently connected to your presenter,
follow step 2 to reconnect it to a new device. The Blue LED will flash
within 3 seconds while the device is reconnecting.
Trouble Shooting (Bluetooth connection)
• Make sure your presenter has enough power.
• Make sure your presenter Bluetooth mode is on.
• Make sure your laptop/computer device Bluetooth is working properly.
• Power indicator light flashing red indicates low battery.
• If your laptop/computer is connected to other Bluetooth devices, you may
need to disconnect some devices before you can connect the presenter.
• If the presenter is still not connecting to your laptop/computer device and
you see several “Targus P38 Remote” on Bluetooth device list, you may
need to remove all “Targus P38 Remote”, then press “Volumn Up” +
“Volumn Down” to make a new device Bluetooth pairing connection.
• If the presenter is still not recognized, make sure the correct version of
software is installed. Verify the Windows and iOS version for compatibility.
OFF/USB/
OFF : Power O
USB : RF 2.4G Mode
: Bluetooth Mode (version 4.2)