Wireless Presenter with Cursor Control Présentateur sans fil avec Commande Curseur USER GUIDE MANUEL DE L'UTILISATEUR
Table of Contents English Wireless Presenter with Cursor Control ......................................2 Français Présentateur sans fil avec Commande Curseur ...............................
AVOID EXPOSURE--HAZARDOUS ELECTROMAGNETIC RADIATION EMITTED FROM THIS APERTURE. LASER RADIATION. DO NOT STARE INTO THE BEAM OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS. CLASS 2 LASER PRODUCT. NEVER POINT A LASER BEAM INTO A PERSON’S EYES OR VIEW A LASER BEAM DIRECTLY, AS PROLONGED EXPOSURE CAN BE HAZARDOUS TO THE EYES. MOMENTARY EXPOSURE FROM A LASER POINTER, SUCH AS AN INADVERTENT SWEEP OF THE LIGHT ACROSS A PERSON’S EYES, MAY CAUSE TEMPORARY FLASH BLINDNESS SIMILAR TO THE EFFECT OF A CAMERA FLASH BULB.
WIRELESS PRESENTER WITH CURSOR CONTROL Introduction Congratulations on your purchase of the Targus wireless presenter with cursor control. This presenter is a combination remote control mouse and laser pointer. With this presenter you can control cursor movement anywhere within 15m (50 feet) of its receiver and project a red laser pointer beam.
Wireless Presenter with Cursor Control Setting Up Your Wireless Presenter Installing The Battery If the presenter is on, slide the on/off switch located on the side of the presenter to the “off” position. Battery Cover Insert the supplied battery, making sure the positive (+) and negative (-) ends of the battery match the polarity indicators inside the battery compartment. Slide the battery cover back into position until it “clicks” firmly into place. Turn on the presenter.
Wireless Presenter with Cursor Control Connecting The Receiver Plug the USB receiver into an open USB port on your computer. Your computer’s operating system will identify the receiver and install the default driver.
Wireless Presenter with Cursor Control Synchronizing Your Wireless Presenter The receiver and presenter should synch up automatically. However, in some cases they may not synchronize properly due to environmental interference or other causes. If this is the case, you must re-establish the link.
Wireless Presenter with Cursor Control Using Your Wireless Presenter 8 6 2 5 3 1 4 7 Button Mouse Mode Presentation Mode 1 Left click Page up 2 Right click Page down 3 Internet page forward Start/Stop 4 Internet page backward Screen goes dark 5 Cursor control No function 6 No function Laser Pointer 7 8 = Mouse mode = Presentation mode On / Off On / Off 7
Wireless Presenter with Cursor Control Safety Measures • To avoid possible eye damage, never point the presenter’s laser at people, especially their faces, or look directly into the presenter’s laser beam. • Avoid pointing the presenter’s laser beam at a mirror or other highly-reflective surface. • Keep the presenter away from young children. • Never view the presenter’s laser beam using telescopic devices, such as a microscope or binoculars.
Wireless Presenter with Cursor Control Technical Support For technical questions, please visit: Internet: www.targus.com/support.asp Email: info.cn@targus.com Product Registration Targus recommends that you register your Targus accessory shortly after purchasing it. To register your Targus accessory, go to: www.targus.com/registration.asp You will need to provide your full name, email address, country of residence and product information.
Wireless Presenter with Cursor Control FCC Statement Tested to Comply This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Wireless Presenter with Cursor Control Product Specification Transmitter RF 2.400GHz-2.483GHz Battery Type AAA battery Effective RF Communication Range 15 meters max RF output power 1 mW max Power Consumption 30 mA max Receiver RF 2.400GHz-2.483GHz Interface USB 1.
ÉVITEZ L’EXPOSITION - RADIATION ÉLECTROMAGNÉTIQUE DANGEREUSE ÉMISE DE CETTE OUVERTURE. RADIATION LASER. NE REGARDEZ PAS LE RAYON - DIRECTEMENT OU A L’AIDE D’INSTRUMENTS OPTIQUES. PRODUIT LASER DE CLASSE 2. NE DIRIGEZ JAMAIS UN RAYON LASER VERS LES YEUX D’UNE PERSONNE ET NE REGARDEZ PAS UN RAYON LASER DIRECTEMENT, CAR L’EXPOSITION PROLONGÉE PEUT ÊTRE DANGEREUSE POUR LES YEUX.
PRÉSENTATEUR SANS FIL AVEC COMMANDE CURSEUR Introduction Nous vous remercions d’avoir acheté un présentateur sans fil avec commande curseur. Ce présentateur combine une souris-commande à distance et un pointeur laser. Grâce à ce présentateur, vous pouvez contrôler les mouvements du curseur dans unrayon de 15m (50 pi) autour de son récepteur, tout en pointant un rayon laser rouge.
Pésentateur sans fil avec Commande Curseur Réglage de votre présentateur sans fil Installation des piles Si le présentateur est allumé, positionnez le bouton on/off situé sur le côté du présentateur en position « off » Couvercle des piles Insérez les piles, en vous assurant que les bornes positives (+) et négatives (-) des piles correspondent aux indications de polarité dans le compartiment des piles. Refaites coulisser le couvercle des piles en position jusqu’au déclic. Allumez le présentateur.
Pésentateur sans fil avec Commande Curseur Connexion du récepteur Branchez le récepteur USB sur un port USB libre sur votre ordinateur. Le système d’exploitation de votre ordinateur identifiera le récepteur et installera le driver par défaut.
Pésentateur sans fil avec Commande Curseur Synchronisation de votre présentateur sans fil Le récepteur et le présentateur doivent se synchroniser automatiquement. Il se peut néanmoins, dans certains cas, qu’ils ne se synchronisent pas correctement à cause d’interférences extérieures ou d’autres causes. Si tel est le cas, vous devez rétablir la connexion.
Pésentateur sans fil avec Commande Curseur Utilisation du présentateur san fil 8 6 2 5 3 1 4 7 Bouton Mode Souris Mode Présentation 1 Clic gauche Page suivante 2 Clic droit Page précédente 3 Page Internet suivante Débuter/Arrêter 4 Page Internet précédente L’écran s’éteint 5 Commande du curseur Aucune fonction 6 Aucune fonction Pointeur laser 7 = Mode Souris 8 Allumer / Eteindre = Mode Présentation Allumer / Eteindre 17
Pésentateur sans fil avec Commande Curseur Mesures de sécurité • Pour éviter de possibles blessures aux yeux, ne pointez jamais le présentateur sur une personne, en particulier le visage, ou regarder directement le faisceau laser du présentateur. • Évitez de pointer le faisceau laser du présentateur sur un miroir ou toute autre surface réfléchissante. • Ternir le présentateur hors de portée des enfants.
Pésentateur sans fil avec Commande Curseur Support technique Pour des questions techniques, veuillez visiter le : Internet : http://www.targus.com/support Courriel : info.cn@targus.com Enregistrement du produit Targus vous recommande d’enregistrer votre accessoire Targus tout de suite après son achat. Enregistrement de votre accessoire Targus à l’adresse suivante : http://www.targus.com/registration.
Pésentateur sans fil avec Commande Curseur Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Cet appareil a une fréquence porteuse variant entre 27,96 et 27,28 MHz. Il est conforme à la norme CNR-310 avec une intensité de champ maximale inférieure à 10 millivolts/m, mesurée à une distance de 3 mètres.
Pésentateur sans fil avec Commande Curseur Spécifications Émetteur Fréquence radio 2.400GHz-2.483GHz Type de pile Pile alcaline AAA Etendue de communication efficace du RF 15 mètres max Puissance de sortie de RF 1 mW max Consommation électrique 30 mA max Récepteur Fréquence radio 2.400GHz-2.483GHz Interface USB 1.
Visit our website at www.targus.com/ca Features and specifications are subject to change without notice. ©2008 Targus Group International, Inc. and Targus, Inc. Visitez notre site: www.targus.com/ca Caractéristiques et spécifications sujettes à modification sans préavis. ©2008 Targus Group International, Inc. et Targus, Inc.