User's Manual

Learning process
NOTE: After the AC power is on, do not press any other button
on the remote control before pressing the (FAN OFF)
button. Doing so will cause the procedure to fail.
Should you desire to use another remote control unit with your
new fan, install one using the steps below:
Turn the main power source off to begin the learning process.
□
Return the power to the unit.
□
Within 30 seconds of turning the fan’s AC power ON, press and
hold the button for 5 seconds to enter the learning function.
Once the receiver has detected the set frequency, the down
light of your fan, if applicable, will blink twice. There is no
indication if your fan is not equipped with a light.
□
1. Fan button. - Press and release the button to turn the fan off.
2. Speed functions
3. button. - Press and release the button to turn the light on or off.
Press and hold the button for 5 seconds to enter the learning function.
□
Fan off.
□
1 - Low speed; 2 - Medium low speed; 3 - Medium speed;
4 - Medium high speed; 5 - High speed; 6 - Extra high speed
□
NOTE: If you are currently using Comfort breeze mode, pressing the button
will cancel Comfort breeze mpde and resume normal fan operation.
NOTE: You must turn the fan on prior to using the timer function.
(Counterclockwise Direction) A downward air flow creates a
cooling effect. This allows you to set your air conditioner on a
higher setting without affecting your comfort.
(Clockwise Direction) An upward air flow moves warm air off the
ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.
4. Timer (2H, 4H, 8H)
5. Fan reverse button (Must be Pushed when the fan is in operation)
Pressing the (2H/4H/8H) button will automatically turn fan off
after 2, 4 or 8 hours.
□
□
□
1
2
3
4
5
6
2H
4H
8H