Owner's Manual

22
TASCAM CD-200SB
4 – Playback
Selecting the playback mode
Press the main unit PLAY MODE/INTRO CHECK [PLAY AREA]
button or the remote PLAY MODE button to cycle through the
playback modes. During playback, however, you can only switch
among continuous, single and random playback modes.
To select programmed playback, press the main unit PLAY
MODE/INTRO CHECK [PLAY AREA] button or the remote PLAY
MODE button when playback is stopped.
The currently selected playback mode is shown on the display as
follows.
Indicator Playback mode
No indicator Continuous playback mode
SNGL
Single playback mode
RAND
Random playback mode
PROG
Program playback mode
The selected playback mode is retained even when the
power is turned off.
NOTE
Immediately after pressing the PLAY MODE/INTRO CHECK
[PLAY AREA] button on the main unit or the PLAY MODE button
on the remote control, the selected mode is shown on the main
display area as follows.
Continuous playback mode set:
CONTINUE
Single playback mode set:
SINGLE
Random playback mode set:
RANDOM
Programmed playback mode set:
PROGRAM
Playback
The following procedures assume that the necessary connec-
tions have been completed, the unit’s power has been turned
ON and the media has been loaded.
To start playback, press the PLAY/PAUSE button on the main
unit or the remote control.
8
Stopping playback
Press the STOP button on the main unit or the remote
control.
8
Pausing playback
Press the PLAY/PAUSE button on the main unit or the
remote control.
In this manual, unless stated otherwise, explanations are given
assuming that the playback mode is continuous. (See “Playback
modes” on page 21.)