Owner's Manual

TASCAM CD-400U
15
2 – Names and Functions of Parts
Rear panel
z ANTENNA FM connector
Connect the included FM antenna here.
Extend the antenna and attach it to a window frame, wall or
other surface where it provides the best reception.
x ANTENNA AM connector
Assemble the included AM loop antenna and connect it to
the AM antenna connector on the back of the unit.
Place the antenna in the position where it provides the best
AM broadcast reception.
c TUNER OUT jacks
These analog RCA pin output jacks always output the sound
from the tuner.
The nominal output level is -10 dBV.
v RS-232C connector
This is a 9-pin D-sub RS-232C control input/output connector.
Connect a computer, for example, here. (see “Using the RS-
232C connector” on page 38)
b Option slot
This slot is for installation of an Ethernet card (sold separate-
ly).
n ANALOG OUT (UNBALANCED) L/R jacks
These are analog RCA pin output jacks.
The default nominal output level is –10 dBV (OFF analog
output level setting), but it can also be lowered in 1dB incre-
ments to −28 dBV (-18dB analog output level setting). (see
“Adjusting the analog output” on page 38)
m ANALOG OUT (BALANCED) L/R jacks
These are balanced XLR analog output jacks.
The default nominal output level is +4 dBu (OFF analog
output level setting), but it can also be lowered in 1dB in-
crements to –14 dBu (-18dB analog output level setting). (1:
GND, 2: HOT, 3: COLD) (see “Adjusting the analog output” on
page 38)
, AC IN connector
Connect the included power cord here.