CD Player User Manual

34 TASCAM CD-500/500B
User data settings (CD-500B only)
You can set whether or not a USER DATA BIT is output
with the digital output from the DIGITAL OUT (AES/EBU)
connector. To set output of the USER DATA BIT, use the 22
U-DATA menu item (default value: ON ).
NOTE
If the signal output from this connector does not play
•
back correctly, set this item to OFF .
The user data setting is retained even when the power
•
is turned off.
Using the parallel control
(CD-500B only)
Using the CONTROL I/O PARALLEL connector, you can
use external parallel control to operate this unit. Two
types of parallel control (normal mode and direct play
mode) can be used with this unit. To set parallel control,
use the 23 PARALL menu item.
Options:
1 Normal mode (default)
In addition to starting, stopping and skipping, fader
start/stop are controlled.
2 Direct play mode
Tracks 1–20 can be played directly.
The pin assignments are as follows
1
8
9
15
PARALLEL
CONTROL I/O
Pin
No.
Function
IN/OUT
MODE: 1 MODE: 2
1 STOP Tally
←
OUT
2
SKIP（Back） Select: 1
IN
3
SKIP（Forward） Select: 2
IN
4 NO DISC Tally
←
OUT
5 EOM
←
OUT
6
SEARCH（Back） Track Play: 1*
IN
7
SEARCH（Forward） Track Play: 2*
IN
8 GND
←
9 PLAY Tally
←
OUT
10 PAUSE Tally FLASH LOAD Tally*** OUT
11
FADER START／STOP Track Play: 3*
IN
12 STOP
STOP／FLASH LOAD**
IN
13 PLAY
Track Play: 4*
IN
14 PAUSE
Track Play: 5*
IN
15 +5V
←
IN: active low external command reception (operates
when ground 30 ms or longer)
OUT: signal for the display of transport status by open
collector (maximum voltage 15 V, maximum current 50
mA)
+5V: maximum supplied current 50 mA
* Track Play 1–5: plays the designated track. The track
played depends on the combination of Select: 1 (Pin
2) and Select: 2 (Pin 3) High (1) and Low (0) settings as
shown below.
** When stopped and the flash start function is on, if the
track beginnings have not yet been loaded, loading
starts. When playing back, playback stops.
*** When the flash start function is on, if the track
beginnings have been loaded completely, High (1)
results. If the track beginnings have not yet been loaded,
or are in the process of loading, Low (0) results.
Pin
No.
Mode 2
function
Select 1 and 2 combination
2 Select: 1 0 0 1 1
3 Select: 2 0 1 0 1
6 Track Play: 1 Track 1 Track 6 Track 11 Track 16
7 Track Play: 2 Track 2 Track 7 Track 12 Track 17
11 Track Play: 3 Track 3 Track 8 Track 13 Track 18
13 Track Play: 4 Track 4 Track 9 Track 14 Track 19
14 Track Play: 5 Track 5 Track 10 Track 15 Track 20
NOTE
The parallel mode setting is retained even when the
power is turned off.
7 – Other Functions