Owner's Manual

16 TASCAM CD-6010
3 – Preparation
Making connections
The illustration below shows an example of connecting other equipment with a CD-6010.
Precautions before making connections
Before connecting other devices to the unit, read their manuals carefully.
•
Turn off the power (or put power into standby mode) for this unit and all equipment that will be connected to it.
•
Connect all the devices to the same power supply line. When using a power strip, for example, use a thick cable with a
•
high current capacity to minimize variation in the power voltage.
TASCAM RC-3F
Footswitch
(sold separately)
TASCAM RC-20
Direct Play Remote
(sold separately)
Headphones
External controller
Computer
USB
DIGITAL
IN
(COAXIAL)
Digital inputs of mixers,
recorders, ampliers, etc.
ANALOG
IN
(UNBALANCED)
Analog inputs of mixers,
recorders, ampliers, etc.
ANALOG IN
(BALANCED)
DIGITAL IN
(AES/EBU)
Connecting a footswitch
Connect a TASCAM RC-3F footswitch (sold separately) to
the REMOTE connector to enable it to control some unit
operations. (See “Controlling the player with a footswitch”
on page 33.)
Connecting a direct play remote
Connect a TASCAM RC-20 direct play remote (sold
separately) to the REMOTE connector to enable it to
control some unit operations. (See “Controlling the player
with a direct play remote” on page 34.)
Connecting headphones
Connect stereo headphones to the PHONES jack on the
front panel. Use the LEVEL knob to adjust the volume.
CAUTION
Before connecting headphones, turn the LEVEL knob to
minimize the volume. Failure to do so might cause sudden
loud noises, which could harm your hearing or result in other
trouble.
Connecting with a computer
Connect the RS-232C connector on this unit to a RS-232C
connector on a computer to allow serial control of this
unit from that computer.
After connecting the unit to a computer, make
transmission settings correctly on this unit. (See “Using
the RS-232C connector” on page 34.)