Owner's Manual

TASCAM CD-6010 19
4 – Menu
Use the unit’s menu system to make various settings.
Among the menu setting items are some that can also be
set using dedicated buttons on the remote control.
Menu structure
The menu structure of the unit includes the following
items.
Menu
number
Item Function set Reference
01 Origin
Original key Page 28
02 TRAY Tray lock Page 21
03 A_CUE
Auto-cue level Page 24
04 Prog Program Page 28
05
FADE Fade in/out playback Page 30
06
EOM_D DISC EOM time display Page 32
07
P onPL
Power on play Page 27
08 Mono
Mono output Page 33
09
RESUM
Resume Page 24
10 EOM_T TRACK EOM time display Page 32
11 Inc-P Incremental play Page 25
12 P-STEP Pitch control steps Page 28
13 232C Baud rate Page 34
14 S-BAC Skip back Page 30
15 IR Remote control reception Page 17
16 INTVAL
Silent interval between
tracks
Page 33
17 FRAM Frame time display Page 32
18 REMOT Footswitch mode Page 33
19 AT T Analog attenuation Page 35
20 RESET
Restore unit to factory
defaults
Page 34
21 INFO View the firmware version Page 35
22 D-OUT Digital output format Page 35
Menu operation basics
The basic procedures for making settings using the menu
system are as follows.
1 When the display shows the usual playback
information, press the MENU button on the unit or
the included TASCAM RC-500 remote control.
The center area of the display shows the menu item
selected. The menu item that was selected the last
time that the unit was in menu mode appears.
Menu item number
Menu item name
Setting
2 Use the unit’s front panel buttons or the remote
control to conduct the following operation to select
the desired menu item.
When using the front panel buttons:
•
Turn the
TRACK SKIP/DATA knob or use the number buttons
to select the menu item, and press the TRACK SKIP/
DATA knob to confirm.
When using the remote control:
•
Use the PREV
and NEXT buttons, as well as the number buttons to
select the menu item, and press the ENTER button
to confirm.
NOTE
The menu item number blinks before it has been
•
confirmed.
When using the number buttons input two digits to select
•
menu items. For example, to select menu number 06,
press the 0 button followed by the 6 button.
The following step (3) applies to all items except
04 PROG , 20 RESET and 21 INFO . See their
explanations for instructions about how to use these
items.
3 Select the desired value.
When using the front panel buttons:
•
Turn the
TRACK SKIP/DATA knob to select the value and
press the TRACK SKIP/DATA knob to confirm the
setting.
When using the remote control:
•
Use the PREV
and NEXT buttons to select the value and press the
ENTER button to confirm the setting.
NOTE
When a value different from the active setting is selected,
•
the value blinks. After the new setting is confirmed, menu
item selection mode appears again.
To cancel a setting change, press the MENU button on the
•
unit or the remote control.
4 Repeat steps 2–3 again as necessary.
5 To exit menu mode, press the MENU button on the
unit or the remote control.