Operation Manual

IMPORTANT SAFETY INSTRUCTIONS
TASCAM CD-RW901SL 9
1 − Introduction
TASCAM CD-RW901SL 9
Connections
The following should be noted when you connect the unit
to other equipment.
It is possible to connect the unit’s DIGITAL COAXIAL
IN , DIGITAL OPTICAL IN , DIGITAL IN (AES/EBU) , and
balanced or unbalanced ANALOG INs (L, R) to other
equipment at the same time. However, the unit can receive
signals from only one digital input at a time. Currently
selected input jack is shown on the display.
Audio signals output from the unit are output from the
balanced or unbalanced ANALOG OUT jacks, as well as
from the DIGITAL COAXIAL OUT , DIGITAL OPTICAL
OUT and DIGITAL OUT (AES/EBU) connector simulta-
neously (but not from the digital outputs in stop mode).
Currently selected input jack is shown on the display.
Beware of condensation
If the unit (or a compact disc) is moved from a cold to a
warm place, or used after a sudden temperature change,
there is a danger of condensation; vapor in the air could
condense on the internal mechanism, making correct oper-
ation impossible. To prevent this, or if this occurs, let the
player sit for one or two hours at the new room temperature
before using.
The pinouts of the CONTROL I/O (parallel) terminal on
the rear panel (see “Rear panel” on page 11) are:
Pin Function
1 STOP TALLY OUT
2 REC TALLY OUT
3 SKIP (forward) IN
4 SKIP (back) IN
5 EOM TALLY OUT
6 REC IN
7 CALL IN
8 GND
9 PLAY TALLY OUT
10 READY TALLY OUT
11 FADER START/STOP
12 STOP IN
13 PLAY IN
14 READY IN
15 +5V
a
a: The maximum current supplied from this terminal is 50 mA.
Tall signals are open collector, with a maximum current
of 50 mA. Input signals are active when low (ground)
for ≥ 30 ms.
A fader start/stop control should be wired according to the
following schematic:
START Pin 11
FADER START/STOP
STOP
Pin 8 GND
Control connections