Manual

5 – Channel modules : Surround operations
TASCAM DM-4800 User’s Manual 91
Pan mode off When pan mode is off, the screen
is much simpler. No pan controls are available, and
the only controls which may be set are the surround
matrix selection and the individual speaker selection
on-screen buttons.
LFE level
The amount of signal sent by each channel to the
LFE output can be set in the
LFE LEVEL screen:
Select the channel or use the cursor to move the box
cursor around the screen, and the POD encoders to
adjust the LFE level.
NOTE
If a channel is not assigned to the LFE, adjusting the
level here will have no effect.
At the bottom of the screen, you can use the POD 1
encoder to select surround matrix 1, 2 or 3 (
SRND SET ).
POD 3 encoder allows a batch LFE level to be set,
and POD 4 sets the scope of the level setting (
ALL ,
ODD , EVEN , or groups of eight channels) for the cur-
rently selected surround matrix.
Use
ENTER to make the batch setting.
Figure 5.30: Surround screen (pan mode off)
Figure 5.31: LFE level