User's Manual
Table Of Contents
- 1 – Introduction
- 2 - Quick Guide
- Playback and mixing
- Recording and mastering
- Creating a new song
- Connecting and setting the input sources
- Setting the guitar as the recording source for TRACK 1
- Adjusting and monitoring the input level
- Recording a guitar to TRACK 1
- Playing back the recording
- Recording a guitar to TRACK 2
- Recording a vocal to TRACK 3
- Mixing the tracks
- Mastering a recording
- Shutting down
- 3 – Names and Functions of Parts
- 4 – Preparation
- 5 - Song Management
- 6 - Basic Recording
- 7 - Recorder Functions
- 8 - Track Editing
- 9 - Using Built-In Effects
- 10 - Mixing Down and Mastering Tracks
- 11 - Various Other Functions
- 12 - SD Card Management
- 13 - Exchanging Data with a Computer
- 14 – Troubleshooting
- 15 – Messages
- 16 – Specifications
26
TASCAM DP-24SD
4 – Preparation
Inserting and removing SD cards
Inserting an SD card
Insert the SD card into the SD card slot on the rear panel as
shown in the illustration until it clicks into place.
NOTE
An SD card is installed in the SD card slot when the unit is
shipped from the factory. If you want to use this card to
record and play tracks, there is no need to reinstall it.
Removing the card
Push the loaded card in gently to eject it.
CAUTION
•
Always turn the power off (standby) before removing an SD
card.
If you remove or insert an SD card when the power is on,
recorded data may be lost and cannot be recovered.
•
SD and SDHC cards that are at least 512 MB in size can be
used.
•
A list of SD cards that have been confirmed for use with this
unit can be found on our web site. Please access to a product
page of this product from the TEAC Global Site (http://
teac-global.com) to find the list or contact the TASCAM
customer support service.
About write-protected SD cards
SD cards have write-protect (lock) switches.
Unprotected Protected
When the protect switch is in the LOCK position, files cannot be
recorded or edited on the card. Slide the switch away from the
LOCK position if you want to record, erase or otherwise change
files on a card.
Powering the unit
As shown in the illustration, connect the included PS-P1220E AC
adapter to the DC IN 12V jack.
AC outlet
DC plug
PS-P1220E
CAUTION
•
Use only the included PS-P1220E AC adapter and power
cord. Use of a different AC adapter could cause malfunction,
fire or electric shock.
•
Be sure to use the included PS-P1220E AC adapter to supply
power to this unit. Power cannot be supplied to this unit via
USB.
NOTE
The AC adapter for the unit includes two types of outlet
plugs. Attach the type of plug that matches the power outlet
that you are using.
Changing the outlet plug
$%
2
1
5
3
4
1 Move the latch on the AC adapter in the direction of the
arrow.
2 Pull off the outlet plug.
3 Replace it with the other outlet plug (A or B).
4 Move the latch on the AC adapter in the direction of the
arrow again.
5 Attach the outlet plug to the AC adapter.
This completes changing the outlet plug.
After changing the outlet plug, confirm that is not
loose or crooked and that everything is normal before
plugging it into an outlet
CAUTION
Do not use the adapter if there is anything abnormal about
the plug after changing it. Use when the plug is abnormal
could cause fire or electric shock. Contact the store where
you purchased this unit or a TASCAM customer support
service to request repair.