User's Manual
Table Of Contents
- 1 – Introduction
- 2 - Quick Guide
- Playback and mixing
- Recording and mastering
- Creating a new song
- Connecting and setting the input sources
- Setting the guitar as the recording source for TRACK 1
- Adjusting and monitoring the input level
- Recording a guitar to TRACK 1
- Playing back the recording
- Recording a guitar to TRACK 2
- Recording a vocal to TRACK 3
- Mixing the tracks
- Mastering a recording
- Shutting down
- 3 – Names and Functions of Parts
- 4 – Preparation
- 5 - Song Management
- 6 - Basic Recording
- 7 - Recorder Functions
- 8 - Track Editing
- 9 - Using Built-In Effects
- 10 - Mixing Down and Mastering Tracks
- 11 - Various Other Functions
- 12 - SD Card Management
- 13 - Exchanging Data with a Computer
- 14 – Troubleshooting
- 15 – Messages
- 16 – Specifications
TASCAM DP-24SD
51
8 - Track Editing
MOVE/PASTE
IN OUT TO
IN OUT TO
The audio data between the IN and OUT points on the MOVE source
track is removed and pasted on the MOVE destination track starting
from the TO point. This operation leaves a silence between the IN and
OUT points on the MOVE source track.
This operation overwrites recorded data on the MOVE destination
track. Therefore, the length of the MOVE destination track is not
changed.
The following parameters are used in this operation.
• SOURCE Track (
1
to
12
,
13/14
to
23/24
,
ALL
)
• IN/OUT/TO
• TARGET Track
MOVE/INSERT
IN OUT TO
IN OUT TO
The audio data between the IN and OUT points on the MOVE source
track is removed and inserted in the MOVE destination track starting
from the TO point. This operation leaves a silence between the IN and
OUT points on the MOVE source track.
This operation inserts recorded data into the MOVE destination track
starting from the TO point. Therefore, the MOVE destination track
becomes longer.
The following parameters are used in this operation.
• SOURCE Track (
1
to
12
,
13/14
to
23/24
,
ALL
)
• IN/OUT/TO
• TARGET Track
OPEN (Insert Silence)
IN OUT
IN OUT
This function inserts silence between the IN and OUT points on
the selected track.
This function splits the track at the IN point and shifts the
recorded data after the IN point to after the OUT point.
Therefore, the track becomes longer.
The following parameters are used in this operation.
• TARGET Track (
1
to
12
,
13/14
to
23/24
,
ALL
)
• IN/OUT
CUT (Remove Part)
IN OUT
IN
This function cuts (deletes) the audio data between the IN and
OUT points on the selected track, and shifts the remaining
recording after the OUT point forward to the IN point. Therefore,
the track becomes shorter.
The following parameters are used in this operation.
• TARGET Track (
1
to
12
,
13/14
to
23/24
,
ALL
)
• IN/OUT