User's Manual
Table Of Contents
- 1 – Introduction
- 2 - Quick Guide
- Playback and mixing
- Recording and mastering
- Creating a new song
- Connecting and setting the input sources
- Setting the guitar as the recording source for TRACK 1
- Adjusting and monitoring the input level
- Recording a guitar to TRACK 1
- Playing back the recording
- Recording a guitar to TRACK 2
- Recording a vocal to TRACK 3
- Mixing the tracks
- Mastering a recording
- Shutting down
- 3 – Names and Functions of Parts
- 4 – Preparation
- 5 - Song Management
- 6 - Basic Recording
- 7 - Recorder Functions
- 8 - Track Editing
- 9 - Using Built-In Effects
- 10 - Mixing Down and Mastering Tracks
- 11 - Various Other Functions
- 12 - SD Card Management
- 13 - Exchanging Data with a Computer
- 14 – Troubleshooting
- 15 – Messages
- 16 – Specifications
52
TASCAM DP-24SD
8 - Track Editing
SILENCE (Erase Part)
IN OUT
IN OUT
This function cuts (deletes) the audio data between the IN and
OUT points on the selected track.
This is the same as leaving silence between the IN and OUT
points, as though there had been no recording.
This operation does not change the length of the track.
The following parameters are used in this operation.
• TARGET Track (
1
to
12
,
13/14
to
23/24
,
ALL
)
• IN/OUT
TIP
You can use this function to delete short noises, for example.
CLONE TRACK (Track Duplication)
Use this function to duplicate a single track or a stereo track to a
different track.
This copies the entire track, so the IN/OUT/TO points have no
effect.
The following parameters are used in this operation.
• SOURCE Track (
1
to
12
,
13/14
to
23/24
)
• TARGET Track
NOTE
If you choose the same track for both
SOURCE Track
and
TARGET Track
,
Same Track
appears and the
operation cannot be executed.
CLEAN OUT (Delete Track)
Use this function to completely erase the selected track.
This deletes the entire track, so IN/OUT/TO points have no effect.
The following parameters are used in this operation.
• TARGET Track (
1
to
12
,
13/14
to
23/24
,
ALL
)