User Manual

TASCAM DR-10SG
9
i Unlit: The recording level is too low.
i Lit yellow: The recording level is low.
i Lit green: The recording level is good.
i Lit red: The recording level is too high.
e Locknut for attachment foot
Left side
r Cord holder
t USB port
This is a Micro-B USB port. Use a cable that
complies with USB standards to connect the
unit to a computer.
When connected, the POWER/STORAGE
screen appears to allow selection of bus power
supply or data transmission by USB with the
computer.
CAUTION
The unit should be connected directly to the
computer, not through a USB hub.
y / jack
This is a combined headphone/line out jack.
Use the included attenuator cable to connect
this to a camera input.
u microSD card slot
Insert and remove microSD cards here.
Open the microSD card slot cover on the left
side. (See “Installing a microSD card” on page
11.)
Right side
i ¤ button
Press and hold the ¤ button for about one
second to turn the unit on/off.
NOTE
A one-second delay in response to this
operation occurs in order to prevent accidental
operation.
Bottom
o Attachment foot
p Tripod mounting threads (1/4-inch)
Noise isolation arm
a Cord holder
s Locknut for attachment foot
d Attachment foot
f Tripod mounting threads (1/4-inch)
CAUTION
• Never lift the connected device by holding this
unit or the noise isolation arm. Application of
excessive load could damage this unit or the
connected device.
• When not in use, disconnect this unit from the
connected device and store it. Application of
excessive load while connected could damage
to this unit or the connected device.