Operation Manual
Table Of Contents
- 1–Introduction
- 2–Names and Functions of Parts
- 3–Preparation
- 4–Recording
- Selecting file format/sampling frequency, and maximum file size
- Set where to save the file
- Setting the input functions
- Placing the unit and making connections
- Adjusting the input level
- Recording
- Recording playback and input sounds together (overdubbing)
- Recording two files with different levels at the same time (DUAL REC)
- Automatic recording and pausing (AUTO REC)
- Creating new files (track incrementing)
- Mark function
- Recording the moment before pushing RECORD (PRE REC)
- Delaying the start of recording (REC DELAY)
- Dividing a file manually (DIVIDE)
- Recording duration
- 5–Working with Files and Folders (BROWSE screen)
- 6–Playback
- 7–Using the Effects
- 8–Using the Metronome
- 9–Connecting with a Computer
- 10–Settings and Information
- 11–Messages
- 12–Troubleshooting
- 13–Specifications
28 TASCAM DR-2d
NOTE
Operation distance varies according to the orientation of
•
the remote control relative to the sensor.
If anything is between the remote control and the receiver,
•
operation might not work.
Precautions for use of the remote control
Remove the battery when you are not using the remote
•
control for a long time (one month or more).
If the battery should leak, thoroughly clean any residue from
•
inside the battery compartment and install a new battery.
When using other devices controlled by infrared rays, use of
•
this remote control might operate these devices by mistake.
Start-up & shutdown
Starting up the unit
Press and hold the /HOME [ª] key on the left side panel
until
TASCAM DR-2d
appears on the display.
The Home Screen appears when the unit starts up.
Start -Up Screen
Home Screen
Shutting down
Press and hold the /HOME [ª] key until
LINEAR PCM
RECORDER
appears on the display.
The power turns off after the unit completes its shutdown
process.
3–Preparation