Reference Guide

12
TASCAM DR-40X
2 – Names and Functions of Parts
6 Input source
This icon shows the input source.
Indicator
examples
Meaning
Input source set to built-in mics
EXT MIC/LINE IN jack set as input source
Second recording level setting (-6 – -12)
when dual recording enabled
When in OVERDUB SEPARATE mode, this
shows that channels 1/2 are a playback file.
When in OVERDUB MIX mode, this shows
that the input source is set to a mix of the
playback file and built-in mic signals
Mix of playback file and EXT MIC/LINE IN
set as input source in OVERDUB MIX mode
NOTE
When a track is soloed, its name appears highlighted
.
7 Level meters
The input signal levels are shown.
During overdub recording, the level of the combined input
and playback sounds is shown.
8 Remaining recording time
The remaining recording time until the selected max file
size is reached appears in hours: minutes: seconds. If the
remaining recording time on the SD card is less, however,
the remaining recording time on the card is shown.
9 Level mode setting status
This icon shows the level mode function setting.
: MANUAL
: LIMITER
: PEAK REDUCTION
: AUTO LEVEL
0 Low cut filter on/off status
This shows whether the low cut filter is on or off.
Low cut filter off
Low cut filter on (example: 220 Hz)
q Tone output setting status
This icon shows whether the AUTO TONE function is on or
off.
: AUTO TONE off
: AUTO TONE on
w File name
The file name that will automatically be given to the
recorded file is shown.
The project name is shown when multiple files have been
recorded in 4-channel recording mode, dual recording
mode or OVERDUB SEPARATE mode.
e Peak value in decibels (dB)
Peak input level values are shown in decibels.