Reference Guide

TASCAM DR-40X
19
3 – Preparation
Inserting and removing SD cards
Inserting cards
1.
Open the SD slot cover on the right side.
2.
Insert the SD Card into the slot as shown in the following
illustration until it clicks into place.
Removing the card
1.
Open the SD slot cover.
2.
Press the SD card in gently and then release it to allow it
to come out.
CAUTION
i
Do not remove the SD card from the unit when it is
connected to a computer by USB.
i
SD cards that meet SD, SDHC or SDXC standards can be
used with this unit.
i
A list of SD cards that we have confirmed for use with
this unit is available on the TEAC Global Site (http://
teac-global.com).
Card write protection
SD cards have protect switches that prevent writing new data
to them.
Writing possible Writing not possible
If you slide the protect switch to the “LOCK” position, file
recording and editing is not possible. Move the switch to the
unlocked position in order to record, erase and otherwise edit
data on the card.
Preparing an SD card for use
In order to use an SD card in this unit, you must format it first.
1.
Confirm that an SD card is installed and turn the power
ON.
2.
The following message appears when a new card or a
card formatted for use with another device is installed in
the unit.
3.
Press the ENTER/MARK button to start formatting.
CAUTION
Formatting an SD card erases all the data on it.
4.
When formatting ends, the Home screen opens. You can
also reformat the card in this unit at any time.
CAUTION
When formatting an SD card, the unit should be operating
on AC power supplied through a TASCAM PS-P520E
adapter (sold separately), USB bus power supplied
from a connected computer, or batteries with sufficient
remaining power.