Reference Guide

24
TASCAM DR-40X
4 – Recording
Preparing the recording inputs
Recording with the built-in mics
Point the mics at the sound source and place the unit in a
stable location where there is little vibration.
Recording with external mics (EXT MIC IN)
Connect external mics to the EXT MIC/LINE IN connectors.
Point the mics at the sound source and place the unit in a
stable location where there is little vibration.
マイク
NOTE
The MIC LR SWAP setting is disabled when an external mic
is being used.
Recording an external device (LINE IN)
Use stereo plug cables to connect to the output of an
external audio device.
Audio device or external
device
CAUTION
i
If the input sound is still distorted after adjusting the
input level of the unit, reduce the playback sound of the
external device.
i
If an external audio device with a fixed output line level
is connected, it might not be possible to control the gain
level of excessively loud input signals. In such cases, use
the headphone jack or other level-controllable output for
connection to the unit.
NOTE
The MIC LR SWAP setting is disabled when an external mic
is being used.
Setting the external input type
When using an external input source, set the EXT IN switch
on the left side panel according to the type of equipment
connected.
LINE
Set to LINE when connecting line output jacks of external
devices to the analog inputs of this unit.
MIC
Set to MIC when connecting mics to the unit.
MIC+PHANTOM
Set to MIC+PHANTOM when connecting condenser mics
that require phantom power (+24V or +48V) to the unit.
CAUTION
Depending on this setting, the input level setting range
changes. For this reason, the input level might change
greatly when this setting is changed. Before changing it,
you should turn the unit off (standby) or turn the output
level all the way down.
MIC