Reference Guide

TASCAM DR-40X
67
12 – USB Connections
Setting the connected device type
1.
When the AUDIO I/F screen is open, use the + or –
button to select (highlight) CONNECT TO, and press the
ENTER/MARK button.
2.
Use the + and – buttons to set the type of connected
device.
Options: PC/Mac (default), iOS
NOTE
i
With Windows, an ASIO driver for the DR-X series can be
used. Check the page for this product on the TASCAM
website (https://tascam.com/us/) for details.
i
With a Mac, the standard OS driver will be used, so there is
no need to install any software.
i
If the connected device type is iOS, this unit will operate
on batteries.
i
Lightning to USB Camera Adapter, for example, is
necessary to connect to an iOS device.
Connecting
1.
When the AUDIO I/F screen is open, use the + or –
button to select (highlight) CONNECT, and press the
ENTER/MARK button.
2.
Press the ENTER/MARK button to enable audio interface
mode and return to the Home Screen.
NOTE
When in audio interface mode, press the MENU button to
access the following functions.
i
MONITOR: Set to DIRECT to mix the mic input and
computer output sounds, enabling input
monitoring without lag.
i
SOURCE: Select the input source.
i
LOW CUT: Set the cutoff frequency of the low-cut filter
during input.
i
EFFECT: Open the effect settings screen.
i
DISCONNECT: End the USB audio interface mode
connection.