Owner's Manual
2 - Names and Functions of Parts
Top panel
a Input channel mixing section-1
Use this section to adjust the input levels of each channel.
b Input channel mixing section-2
Use this section to choose input sources for each channel,
adjust compressors and equalizers, and set levels sent to
each bus (MAIN MIX L/R, SOLO L/R, AUX1, AUX2/FX, SUB L/R).
(see “Input channel mixing section-2” on page 13)
c Equalizer section
Use this section to connect headphones and adjust the output
equalizer. (see “Equalizer section” on page 14)
d Screen operation section
Use this section to operate the meter, home and MENU
screens shown on the display. (see “Screen operation section”
on page 14)
e Monitoring section
Switch Bluetooth device input destinations, switch
monitoring destinations, and adjust AUX OUTPUT AUX 1/2
jack output levels. (see “Monitoring section” on page 15)
f Analog output adjustment section
Adjust the output levels of the built-in eects, and the
MAIN OUTPUT and SUB OUTPUT jacks. (see “Analog output
adjustment section” on page 16)
Input channel mixing section-1
1 GAIN knobs and SIG indicators (1-6, 7/8-9/10)
Use the GAIN knobs to adjust the input levels of each
channel.
its SIG indicator will light green when a signal is input (-40dB
or higher).
If a SIG indicator stays lit red continuously, lower the GAIN
knob.
2 LOW CUT switches (1-6, 7/8-9/10)
Turn this switch on (pushed in) to enable low cut lters that
cut noise and other sounds at low frequencies.
3 INST switches (1-6, 7/8-9/10)
Set according to the MIC/LINE (BAL)/INST TRS input jack input
sources.
Turn the INST switch on (pushed in) when connecting an
guitar, bass or other equipment with high output impedance.
Turn the INST switch o (not pushed in) when connecting
electronic instruments, audio devices, mics and other
equipment.
12 TASCAM Model 12