Reference Manual

ManualsBrandsTascam ManualsAudio Interfaces & SystemsSERIES 102i USB Audio/MIDI Interface

TASCAM SERIES 102i / SERIES 208i

5 - Using the Settings Panel

Initializing the Settings Panel

Select this to reset all settings in the Settings Panel.

ATTENTION

Depending on the input signal level, sudden loud sounds

could be output unexpectedly. We recommend initializing

settings when no sound signals are being input from

instruments or playback devices.

NOTE

The items on the INFORMATION page will not be initialized.

1. In the menu bar, open the View menu, and click Initialize.

The following confirmation message will appear.

Windows version

2. Click the “OK” button in the message window to reset the

Settings Panel settings to their default values.

The items reset are as follows.

Following items on MIXER page

i EQUALIZER area settings: all initialized

i COMPRESSOR area settings: all initialized

i REVERB area settings: all initialized

i φ (phase) buttons (all channels): off

i THRU buttons (all channels): off

i EQ buttons (all channels): off

i COMP buttons (all channels): off

i PRE/POST buttons: off

i AUX 1-4 knobs (all channels): -inf.

i SOLO buttons (all channels): off

i MUTE buttons (all channels): off

i Pan sliders (all channels): center (C)

i Channel faders (all channels): 0.0 dB

i LINK buttons (all channel pairs): off

i REVERB buttons: on

i REVER RETURN knob: -inf.

i AUX MASTER 1/REVERB knob: 0 dB

i AUX MASTER 2-4 knobs: 0 dB

i STEREO MASTER fader: -infinity

Following items on ROUTING page

i LINE OUT 1: MASTER L

i LINE OUT 2: MASTER R

i LINE OUT 3: AUX 1 (SERIES 208i only)

i LINE OUT 4: AUX 2 (SERIES 208i only)

i LINE OUT 5: AUX 3 (SERIES 208i only)

i LINE OUT 6: AUX 4 (SERIES 208i only)

i LINE OUT 7: COMPUTER 1 (SERIES 208i only)

i LINE OUT 8: COMPUTER 2 (SERIES 208i only)

Resetting the reverb settings

Select this to reset the settings in the REVERB section on the

MIXER page.

ATTENTION

After resetting, you cannot restore the previous settings.

1. In the menu bar, open the View menu, and click Initialize

Reverb.

The following confirmation message will appear.

Windows version

2. Click the “OK” button in the message window to reset the

reverb settings to their default values.

The items reset and their default values are as follows.

Reverb

type

Reverb knobs

PRE DELAY REVERB TIME DIFFUSION

HALL 90 ms 2.7 s 20

ROOM 25 ms 1.4 s 60

LIVE 6 ms 2.6 s 50

STUDIO 60 ms 0.4 s 70

PLATE 42 ms 2.7 s 50

The reverb type will also be set to HALL (default value).

NOTE

Click the “Cancel” button to return to the previous screen

without initializing.