User's Manual

AXON™ 4 Jan 2010
TASER International Private & Confidential 3
Introduction
Warning
Changes or modifications not expressly approved by the manufacturer could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC/IC NOTICE:
This device meets the body worn human exposure limits found in OET Bulletin 65, 2001,
and ANSI/IEEE C95.1, 1992. Proper operation of this radio according to the instructions
found in this guide will result in exposure substantially below the FCC’s recommended
limits. To comply with the FCC and ANSI C95.1 RF exposure limits, this device has
been tested for compliance with FCC RF Exposure (SAR) limits in the typical
configuration. It is recommended that the antenna must not be co‐located or operating in
conjunction with any other antenna or radio transmitter.
NOTE: The radiated output power of this wireless device is far below the FCC radio
frequency exposure limits. Nevertheless, this device should be used in such a manner that
the potential for human contact (i.e., touching the wireless unit) during normal operation
is minimized.
NOTE: Unauthorized modifications could void the user’s authority to operate the
equipment.
RSS 210 Warning Statement: The installer of this radio equipment must ensure that the
antenna is located or pointed such that it does not emit RF field in excess of Health
Canada limits for the general population; consult Safety Code 6, obtainable from Heath
Canada’s website www.hc‐sc.gc.ca/rpb.
THIS MODEL DEVICE MEETS THE GOVERNMENT’S REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES: