User manual

RS232-ADC16/24
3 Bringing into service
The following steps illustrate how to setup the device correctly.
1. Connect DSUB-9 adaptor to serial port.
2. Configure serial port to 115200 baud,
8N1 (8 bit data, no parity, 1 stop bit).
3. Power the device.
Use VIN (pin 24) and GND (pin 18) pins
of DSUB-25 connector. (15V max)
After this, a terminal program should display RS232-ADC's boot message.
Referring to the advice given in the boot message sending a questionmark will
produce a help text.
Page 4/22