User manual

Linux Guide taskit GmbH
Device drivers -> Graphics support
To enable the driver activate the entry “AT91/AT32 LCD Controller support”.
To disable the driver deactivate the entry “AT91/AT32 LCD Controller support”.
Configure backlight
To change the backlight configuration start menuconfig and go to:
Device drivers -> Graphics support
To enable the backlight activate the entry “taskit Panel-Card Backlight Driver”.
To disable the backlight deactivate the entry “taskit Panel-Card Backlight Driver”.
Input device(s)
To change the input driver configuration start menuconfig and go to:
device drivers -> Input device support -> Miscellaneous devices
To compile the rotary knob driver as module set the enty “Panel-Card Starterkit knob
driver” to 'M'. To compile the driver into the kernel (started automatically) set the entry to
'*'. To deactivate the driver set the entry to ' ' (empty).
11.4.4. MoLUX
General kernel configuration
The default kernel configuration is loaded by entering:
ARCH=arm make molux_defconfig
This configuration has to be loaded at least one time after decompressing and compiling
the kernel sources from the starterkit-CD.
Configure display driver
To change the backlight configuration start menuconfig and go to:
Device drivers -> Graphics support
To enable the backlight activate the entry “AT91/AT32 LCD Controller support”.
To disable the backlight deactivate the entry “AT91/AT32 LCD Controller support”.
Configure backlight
To change the backlight configuration start menuconfig and go to:
Device drivers -> Graphics support
To enable the backlight activate the entry “taskit Panel-Card Backlight Driver”.
To disable the backlight deactivate the entry “taskit Panel-Card Backlight Driver”.
Input device(s)
To change the input driver configuration start menuconfig and go to:
device drivers -> Input device support -> Miscellaneous devices
Page 44 of 65 Version 1.26 (2008-04-30)