Instructions / Assembly

Assembly & Installation Instructions
MODEL: A60001、A60002
IMPORTANT SAFETY INSTRUCTIONS:
•
Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure
full compliance with N.E.C. requirements. If there are any questions, contact a qualified electric contractor.
•
Warning: This product can expose you to chemicals including lead, which is known to the State of
California, to cause cancer or birth defects or other reproductive harm. For more information,
please go to www.P65Warnings.ca.gov
•
Caution: Electrician installation highly recommended. All glass is fragile, use care when handling glass
component(s) and or lamp(s). Read instructions carefully and turn electricity off at the main circuit breaker
panel before beginning installation.
Important Notice:
This is a generic instruction sheet used for various fixtures.
The finish, numbers of heads/arms, and style of fixture / glass / shade / diffuser may vary.
(Required Supply Circuit: 120V, 60Hz. Bulb Type: 3*E26*60W Max)
Compatible Bulb Type
(NOT Included)
The mostly suggested bulb type is 8W LED ST58 bulb
COMPONENTS INCLUDED IN THE PACKAGE
Fixture with Cord and Canopy / Shades/ Mounting Plate
Parts included in parts bag.
Parts X 2 for 2 pack item
ASSEMBLY & INSTALLATION STEPS:
1. Open the box from top, take out all the components, parts bag and manual from the box carefully.
2. Check all the components against the parts list. Make sure get each parts on list. If any parts missing
and glass damage, please contact the seller to get a replacement.
Parts are NOT included for which is shown as 0 under QTY.
PARTS LIST (Parts QTY X 2 for 2 pack item)
Part Name
QTY
Code
Part Name
QTY
Code
Junction Box
0
A
Thread Fastener
4
H
Leading Wire
0
B
Cap Nut
2
I
Wire Nut
3
C
Cord
2
J
Universal Mounting Bracket
1
D
Fixture Frame
1
K
Stud
2
E
Shade
3
L
Mounting Screw
2
F
Socket Ring
3
M
Rectangular Canopy
1
G
Light Bulb
0
N
3. Refer to the illustration while doing assembly and follow the steps as below:
I
Loose the thread fasteners and adjust the cords to proper height before installation
II
Attach the mounting bracket (D) to the junction box (A) by two mounting screws (F).
III
Connect wires according to the wiring diagram as below.
IV
Attach the canopy (G) to the studs (E) on the mounting bracket (D), fix with two cap nuts (I).
V
Assemble the shades (L) on to socekt and fasten the socket rings (M), screw on the bulbs (N).
Illustration of assembly and wiring:
I.
J
H
II.
F, D
A
III.
J, B
C
IV.
I, G
E
V.
N, M, L
K