Instructions / Assembly

Assemble M ounting Rack :
1. Ensure center rods (7) and adjustment rods(10) are firmly connected and that the adjustment rods can move
easily within their sockets.
2. Slide the lower rods (8) into the other end of the center rods (7).
3. Remove the long bolts from the center rods(7) and slide the upper rods (6) to the center rods.
4. M easure the height of the scene. Slide (6) to the correct distance to fit the height of your preferred awning brace,
fasten the long bolts. Add pressure feet (A) to the top of each of the upper rods (6).
5. Remove the nut and gasket from tube (1), install the upper gear module(9), and reinstall the gasket and nut to
secure.
6. Fit awning into desired space, with pressure feet placed flush with a hard surface on the bottom and the top feet
aligned to m eet a hard surface above when tightened.
7. Twist bottom feet to tighten and loosen the tension between both ends until the top pressure feet meet the top
surface.
8. Both feet should be affixed against the surfaces until the awning is firmly positioned in the desired space.
9. Use short bolts (B) to attach the front of the awning(4)to the adjustment rods(10).