Operation Manual

6
6. Stand: Do not place the product on an unstable
cart, stand, tripod or table. Placing the product
on an unstable base can cause the product to
fall, resulting in serious personal injuries as
well as damage to the product.
Use only a cart, stand, tripod, bracket or table
recommended by the manufacturer or sold with
the product. Use only mounting hardware
recommended by the manufacturer.
7. Use care when moving the product on a rolling cart. Sudden stops, excessive force
and an uneven floor surface may cause the product to fall from the cart.
8. Ventilation: The vents and other openings in the cabinet are designed for
ventilation. Do not cover or block these vents and openings because insufficient
ventilation can cause overheating and/or shorten the life of the product. Do not
place the product on a bed, sofa, rug or other similar surface, because they can
block the ventilation opening. This product is not designed for built-in installation,
do not place the product in an enclosed environment such as a bookcase or rack,
unless proper ventilation is provided or the manufacturer's instructions are
followed.
9. The LCD panel is made of glass. Therefore, it can break when the product is
dropped or struck.
10. The LCD panel is a technologically advanced product giving you fine picture
details. Occasionally, a few non-active pixels may appear on the screen as a fixed
point of blue, green or red. These non-active pixels are considered acceptable
according to industry standards.
11. An outside antenna system should not be located in the vicinity of overhead power
lines or other electric light or power circuits, or where it can fall into such power
lines or circuits. When installing an outside antenna system, extreme care should
be taken to keep from touching such power lines or circuits as contact with them
may lead to severe personal injury.