Manual

SAFETY DEVICES
(PT58 S-D, PT92 C-D, PT92 AF-D, PT99 AF-D, PT100 AF-D,
PT101 AF-D, PT908, PT911, PT938, PT940, PT945 and PT957)
1. The FIRING PIN BLOCK (4) is permanently locked preventing the FIRING
PIN (5) from going forward which could cause accidental discharge should
the pistol be dropped.
The FIRING PIN BLOCK (4) is only released at the TRIGGER (1) final stage
position, allowing the FIRING PIN (5) to advance as soon as it receives the
HAMMER (6) impact energy. The release is done through the following
movement series: TRIGGER (1), TRIGGER BAR (2), FIRING PIN BLOCK
LEVER (3) and FIRING PIN BLOCK(4).
2.By moving the SAFETY upward you will disengage the hammer and sear
simultaneously. The SAFETY was designed to allow AMBIDEXTROUS use
and it enables a rapid change from safe to fire position.
3. When a cartridge is loaded in the chamber the EXTRACTOR end
protrudes and its red colored surface can be easily seen or felt without the
need of moving back the SLIDE.
CAUTION - Taurus Models PT111, PT140, PT911, PT938, PT940 and
PT957 manufactured before July, 2000 do NOT contain a loaded
chamber indicator.
To determine if chamber is loaded, make sure your
finger is not on the trigger or inside the trigger guard and pull slide to rear
and visually inspect the chamber. In any case, always inspect the chamber
visually by pulling the slide back slowly and looking into the chamber while
keeping your finger well clear of the trigger and trigger guard and keeping the
muzzle pointed in a safe direction.
DANGER: CLEARING THE CHAMBER
To clear the chamber of a Taurus Pistol, first make sure the muzzle is pointed
in a safe directon. Remove magazine and set aside. While keeping your
finger well away from the trigger and trigger guard, disengage the manual
safety, and pull the slide smartly to the rear. The cartridge will eject. Lock the
slide open and visually inspect the chamber to make sure the pistol in
unloaded. You may then close the slide and secure your firearm.
21
ALWAYS KEEP THE MUZZLE POINTED IN A SAFE DIRECTION.
PT58, 92, 92C, 99, 100, 101, 908, 911, 938, 940, 945, 957.