MSDS

Page 1 of 2
MATERIAL SAFETY DATA SHEET U.S. Department of Labor
U.S. Department of LaborU.S. Department of Labor
U.S. Department of Labor
May be used to comply with OSHA’s Hazard
Occupational Safety And Health Administration
Communication Standard, 29CFR 1910.1200.
SIMILAR TO FORM OSHA 174
Standard must be consulted for specific requirements.
DATE PREPARED 1 January 2012
IDENTITY (As Used on Label and List) ACUTE HEALTH FIRE REACTIVITY
OIL-FLO 141
NFPA 1 1 0
SAFETY SOLVENT CLEANER
0=LEAST 1=SLIGHT 2=MODERATE 3=HIGH 4=EXTREME
S ECTION 1
M ANUFACTURER :
TITAN LABORATORIES
2935 IRVING BLVD., STE. 209
DALLAS, TEXAS 75214 U.S.A.
++214-638-1200
I MPORTER :
S ECTION II --- H AZARDOUS I NGREDIENTS /I DENTIFY I NFORMATION
HAZARDOUS COMPONENTS (Specific Chemical Identity; Common Name(s)
OSHA VPEL ACGIH TLV OTHER LIMITS % (OPTIONAL)
1. ALIPHATIC HYDROCARBONS 68%
CAS # 64742-96-7
2. GLYCOL ETHER EB25 PPM –TWA (Skin) 4%
CAS # 111-76-2
3. COCO ALKYLAMIDE, N,N-BIS 4%
CAS # 68603-42-9
4. SURFACTANTS 20%
CAS # 9016-45-9 and Trade Secret *
5. FRAGRANCE AND MISC. 2%
6. DI WATER 2%
>ITEMS 1 AND 2 ARE HAZARDOUS WITHIN OSHA’S HAZARD COMMUNICATION STANDARD 29 CFR 1910.1200.
>ITEMS 3 THROUGH 6 ARE NON-HAZARDOUS* NO EXPOSURE LIMITS ESTABLISHED
>CONTAINS NO BENZENE, CHLORINATED HYDROCARBONS OR CFC’s.
S ECTION III --- P HYSICAL /C HEMICAL C HARACTERISTICS
BOILING POINT 188-288°C (370-550°F)
SPECIFIC GRAVITY (H
2
O = 1): 0.834
VAPOR PRESSURE (MM HG) 0.078 mm Hg @ 25°C
MELTING POINT: NOT APPLICABLE
VAPOR DENSITY (AIR = 1) >5 (N-Butyl Acetate = 1) EVAPORATION RATE : <0.10
SOLUBILITY IN WATER : COMPLETE pH: (H
2
O = 7): 7.0
APPEARANCE AND ODOR: COLORLESS TO AMBER LIQUID, LOW ODOR, GREEN APPLE NOTES
S ECTION IV --- F IRE AND E XPLOSION H AZARD D ATA
FLASH POINT (METHOD USED)
71°C ( 160
O
F) PMCC FLAMMABLE LIMITS LEL 0.6% UEL 7.0%
EXTINGUISHING MEDIA
Foam, carbon dioxide or dry chemicals
SPECIAL FIRE FIGHTING
PROCEDURES
Wear self-contained breathing apparatus with full facepiece operated in
the positive pressure demand mode. Normal combustion causes co2 and
water vapor. Incomplete combustion can form CO .
UNUSUAL FIRE AND EXPLOSION
HAZARDS
Do not weld on or near drums even if empty. Vapors are heavier than air
and may travel along the ground to a pilot light or other flame at a distant
location.