Soft Serve Freezer Operating Instructions 161

Model 161 Operating Procedures

Step 5

Press the WASH key. This will cause the sanitizing

solution in the freezing cylinder to be agitated. Allow it

to agitate for five minutes.

Figure 20

Note: Non--Softecht machines: Place the power

switch in the WASH position. This will cause the

sanitizing solution in the freezing cylinder to be

agitated. Allow it to agitate for five minutes.

Figure 21

Step 6

Place an empty pail beneath the door spouts and raise

the draw valves. Momentarily pull down the center

draw handle to sanitize the center door spout. Draw off

all of the sanitizing solution. When the sanitizer stops

flowing from the door spouts, lower the draw valves

and place the power switch in the OFF position.

Step 7

With sanitized hands, stand the air tube in the corner

of the mix hopper . Place the mix level float on the mix

level float stem (non--Softecht machines only).

Figure 22

Repeat Steps 1 through 7 for the second freezing

cylinder.

Priming

Prime the machine as close as possible to the time of

first product draw.

Step 1

With a pail beneath the door spouts, open the draw

valves. Fill the mix hopper with FRESH mix and allow

it to flow into the freezing cylinder. This will force out

any remaining sanitizing solution. When full strength

mix is flowing from the door spouts, close the draw

valves.

Note: Use only fresh mix when priming the

machine.

Step 2

When the mix has stopped bubbling down into the

freezing cylinder, install the air tube in the mix inlet

hole.

Figure 23