User's Manual

Models 345, 346, 349, 355Operating Procedures

Figure 43

Step 12

Install the mix feed tube into the mix inlet hole in the

bottom of the mix hopper .

Figure 44

Step 13

Sanitize and install the hopper cover. Lock the cover

into place. Attach the vinyl tube to the pressure relief

valve on the hopper cover. Position the open end of the

vinyl tube into the rear drip pan.

Figure 45

Step 14

Press the BEATER key. Agitate the solution in the

freezing cylinder for five minutes.

Figure 46

Step 15

With a pail beneath the door spout, open the draw

valve and drain all the solution from the mix hopper and

the freezing cylinder. Press the OFF key and close the

draw valve.

Figure 47

Step 16

Disconnect the syrup connector in the sanitizing

solution.

Repeat Steps 2 through 14 for the remaining freezing

cylinder(s).

Step 17

Remove the right side panel and install the rear white

drip pan.