User's Manual

Models 345, 346, 349, 355 Operating Procedures

Step 4

Remove the right side panel and take the rear, white

drip pan to the sink for further cleaning.

Step 5

Remove the following parts: seals and o-rings from the

drive shafts, drive shaft seal bushings from drive shaft

seals, caps and springs from freezer doors, screws

and draw handle slides from freezer doors, pivot pins

from draw valves, draw valve handles from freezer

doors, draw valves from freezer doors, o-rings from

draw valves, prime plugs from freezer doors, o-rings

from prime plugs, o-rings and front bearings from

freezer doors, o-rings from mix hopper covers.

Discard all o-rings and replace them with new ones.

Note: To remove o-rings, use a single service towel to

grasp the o-ring. Apply pressure in an upward direction

until the o-ring pops out of its groove. With the other

hand, push the top of the o-ring forward. It will roll out

of the groove and can be easily removed. If there is

more than one o-ring to be removed, always remove

the rear o-ring first. This will allow the o-ring to slide

over the forward rings without falling into the open

grooves.

Step 6

Using a single service towel, wipe the lubricant off the

parts. Brush-clean all disassembled parts in the

cleaning solution. Make sure all lubricant and syrup is

removed. Place all the cleaned parts on a clean, dry

surface to air-dry.

Step 7

Wipe clean all the exterior surfaces of the freezer .