User's Manual

Model C300 NPOperating Procedures

Step 3

Check the scraper blade for any nicks or signs of

wear. If any nicks are present, replace the blade. If

the blade is in good condition, place the clip over the

blade. Place the rear scraper blade and clip over the

single holding pin on the beater (knife edge to the

outside). Holding the blade on the beater, turn it over

and install the front blade the same way.

Figure 9

Step 4

Holding the blades in position, insert the beater

assembly into the freezing cylinder and slide it into

position over the drive shaft. Turn the beater slightly

to be certain that the beater is properly seated.

When in position, the beater will not protrude beyond

the front of the freezing cylinder.

10616

Figure 10

Step 5

Install the white, plastic guide bearing on the short

end of the baffle assembly. Slide the o-ring into the

groove on the long end of the baffle assembly and

lubricate the o-ring. Do not lubricate the guide

bearing.

Figure 11

Step 6

Insert the short end of the baffle assembly into the

pilot hole in the center of the drive shaft. The hole in

the baffle assembly shaft should be rotated to the 12

o'clock position.

Step 7

Assemble the freezer door with the “Ice Buster”

(door spout clearing device). To assemble the door

with the ice buster, install the o-rings on the draw

valve and lubricate.

11321

Figure 12