User's Manual

39
Models C708 & C716 Operating Procedures
120209
Step 9
Secure the pump parts in position by sliding the
retaining pin through the cross holes located at one
end of the pump cylinder. (See Figure 37.)
Figure 37
Note: The head of the retaining pin should located
at the top of the pump when installed.
Step 10
Assemble the feed tube assembly. Slide the check
ring into the groove of the feed tube.
(See Figure 38.)
Figure 38
Step 11
Install one red o-ring on each end of the mix feed
tube, and thoroughly lubricate. (See Figure 39.)
Figure 39
Step 12
Lay the pump assembly, pump clip, cotter pin, mix
feed tube assembly, and agitator in the bottom of
the mix hopper for sanitizing. (See Figure 40.)
Figure 40